Difference between revisions of "Boffer Specifications and Creation"

From Shadow Accord
Jump to: navigation, search
(Construction:)
 
(28 intermediate revisions by 2 users not shown)
Line 1: Line 1:
 
+
== Weapon Checks ==
== Cloth, Latex, or Duct Tape? ==
+
* '''All weapons must be checked each game prior to use.'''
Most weapons at Shadow Accord are latex weapons. These look nice and good looking weapons help with immersion just like good costumes and props.
+
* Weapons will be checked during the check-in process by Safety, a Head of Staff, Executive Officer, or the Deco Weapon Specialist.
 
 
Cloth covered boffers are primarily used for natural weapons like claws, tentacles, or fists.  A basic description of how to build cloth covered boffers is available below.
 
 
 
Duct Tape weapons are generally discouraged. The Duct tape adds weight and stiffness to a weapon that may cause a stinging to anyone hit with one.  Also they generally do not look all that good and can detract from immersion.
 
  
 
== Weapon Specifications ==
 
== Weapon Specifications ==
 +
=== Boffer Weapons ===
 +
==== Length: ====
 +
* Fist: 12 in. striking surface
 +
* Claws: 20-24 in. striking surface
 +
* Tentacles: 26-30 in. striking surface
 +
* Maximum length for all weapons: 72 inches
  
=== Boffer Attacks ===
+
=== Ranged Weapons ===
'''Daggers:''' up to 12 inches of striking surface, 6 inch handle.
+
* Bow: Max limit 35 lb pull.
 +
* Arrows: Store bought LARP-safe arrows only (No homemade arrows will be considered).
 +
* Safety has the final say whether the bow/crossbow is suited for game.
  
'''All other one-handed melee weapons:''' up to 24 inches of striking surface, 32 with handle.
+
== Store bought (manufactured)  Latex weapons ==
 +
These weapons are acceptable so long as they pass the safety check.
 +
== Cloth, Latex, or Duct Tape? ==
 +
Most weapons at Shadow Accord are latex weapons. These look nice. Good looking weapons help with immersion, just like good costumes and props.
  
'''Two-handed melee weapons:''' up to 36 inches of striking surface, 48 with handle.
+
Cloth covered boffers are primarily used for natural weapons like claws, tentacles, or fists. A basic description of how to build cloth covered boffers is available below.
 
 
'''Polearms:''' up to 72 inches, handles may vary.
 
 
 
'''Fist Boffers:''' up to 12 inches of striking surface, 18 with handle. Must be black.
 
 
 
'''Claws:''' up to 24 inches of striking surface, 32 with handle. Must be black with a white/silver claw mark.
 
 
 
'''Tentacles:''' up to 36 inches of striking surface, 48 with handle. Must be black with a white/silver tentacle mark.
 
 
 
=== Ranged Weapons ===
 
 
 
Max limit 35 lbs with store bought LARP-
 
safe arrows.  
 
  
No homemade arrows will be considered. Bows/crossbows must be checked out by Deco and Safety at each event prior to use in game.  
+
As with all weapons presented at game, a weapon needs to pass both safety AND aesthetics. Duct tape is an acceptable material provided it can pass both.
  
Deco and Safety has the final say as to if the bow/crossbow is suited for game.
+
== Construction materials ==
 +
=== Cores: ===
 +
==== Acceptable core materials: ====
 +
*'''Composite materials''' -  Kite Spar/Graphite/Carbon fiber/Fiberglass core(graphite/carbon fiber are common materials used in the shaft of a golf club driver. these can be acquire at second  hand stores for as little as 5 dollars each and remain acceptable for use as the core of a boffer weapon).
  
Additional information on weapons can be found in the [[rules]].
+
==== Un-acceptable core materials: ====
 +
*'''Organic materials''' - this includes, Wood, Bamboo, Rattan, ect. that can mold and mildew.
 +
*'''PVC''' - On the whole lightweight PVC is too flexible for our standards, while PVC that is rigid enough, is too heavy for our standards.
  
== Making a Boffer ==
+
==== Closed cell foam: ====
 +
* Camp pad - found at most stores that carry sporting goods
 +
* L-200 foam  - (example [http://foammart.com/index.php?nsc=minicell&pcat=closed-cell Foam Mart online])
 +
* EVA Foam - (example “Anti-stress floor pads” / “exercise mats”  [http://www.harborfreight.com/4-piece-anti-fatigue-foam-mat-set-94635.html?utm_medium=email&utm_campaign=4112b&utm_source=1002 Harbor Freight online])
 +
* Ensolite - (example “Pipe insulation” [http://foammart.com/index.php?nsc=ensolite&pcat=closed-cell#categories Foam Mart online])
  
The following is basic walkthrough on creating a boffer:
+
==== Exterior: ====
 +
* Latex - for shaped / “bladed” weapons.
 +
** Latex weapons must be sealed with silicone protectant (some players are allergic to latex).
 +
* Cloth (Black in color) - Brawl boffers, claws boffers, & tentacle boffers.
 +
** Claws and tentacles must be black in color with the appropriate white/silver mark.
 +
** Claws and tentacles can be made of latex; they must still be black in color and carry the correct symbol.
 +
** Claw and Tentacle symbol [https://drive.google.com/drive/#folders/0Bwm-WYMok2F0X0VwWjZlS29RQm8 examples].
  
<ol>
+
==== Construction: ====
<li> Get a core. Acceptable cores include graphite cores found in golf clubs, kite spar, and PVC tubes (not the thin wall
+
* Foam must be secured to the core and immobile, either with glue or tape.
ones).
+
* Tape may be used during construction of the core to cover the tip to prevent it from puncturing foam.
<li> Using clear tape (packing tape) attach some small foam strips to the core of the weapon. This is to prevent the
+
* Tip must be padded to prevent the core from stabbing through.
core from rattling inside the fun noodle.
+
* Latex weapons are recommended to include additional tip security, such as vinyl tubing between the hard core and the foam at the tip.
<li> Cut the appropriate length of fun noodle for the weapons length (about two inches longer then the core of the weapon).
+
* Pommels are required for weapons donated to Shadow Accord.
<li> Taper one end of the fun noodle. This will help in attaching the noodle to the core.
+
* The outer layer of all non-latex boffers must have a cloth covering.
<li> Slide core into fun noodle. The strips of foam attached to the core should make it a snug fit. For the “best” fit, have
 
the end, or tip, of the core no closer than approximately 2 inches below the end of the fun noodle.
 
<li> Using clear or duct tape affix the fun noodle, at the bottom of the noodle, to the core (where you had tapered it
 
earlier. Be sure to make this a solid attachment by tugging on the noodle away from the core. If done properly the
 
noodle will not budge very much (keep in mind, it is foam, and if you pull too much it will come apart).
 
<li> At the top of the weapon, stuff remaining foam in the 2 inch deep hole. This is to prevent the tip of the weapons
 
core from poking through and potentially stabbing someone. Another good method, along with stuffing the tip, is
 
to cover the top of the weapon with some flat foam. The tip of the weapon should be reasonably flat, bigger than
 
an eye socket. Use clear tape to affix the flat foam cover to the end of the fun noodle.
 
<li> Cover the weapon with a strip of clear packing tape. This will extend the life of the weapon.
 
<li> Cover the weapon in a cloth tube. Make sure this will not fly off the weapon easily. These can be made very simply
 
by any seamstress of tailors. Also, using layers of panty hose works fine as well.
 
</ol>
 
  
Addendum:
+
== Other Notes ==
 +
* Any member of Staff can remove an item from game if it is determined to be unsafe or very distracting to the immersion of the game. (A rule that has always been apart of Shadow Accord, though rarely used).
 +
* Additional information on weapons can be found in the [[rules]].
  
*Feel free to add a pommel to your boffer weapon. Use the same techniques for the “blade” of your weapon on
+
[[Category: Shadow Accord Organization]]
the end of your handle, except in much shorter lengths. This may prevent any injury if someone is accidentally hit
+
[[Category: Safety Team]]
with the back end of your weapon.
 
*A “courtesy padding” is allowed at Shadow Accord, but by no means is necessary. These paddings are open cell
 
foam on the tips. These will be counted as total length of the weapon.
 

Latest revision as of 22:36, 10 August 2016

Weapon Checks[edit]

  • All weapons must be checked each game prior to use.
  • Weapons will be checked during the check-in process by Safety, a Head of Staff, Executive Officer, or the Deco Weapon Specialist.

Weapon Specifications[edit]

Boffer Weapons[edit]

Length:[edit]

  • Fist: 12 in. striking surface
  • Claws: 20-24 in. striking surface
  • Tentacles: 26-30 in. striking surface
  • Maximum length for all weapons: 72 inches

Ranged Weapons[edit]

  • Bow: Max limit 35 lb pull.
  • Arrows: Store bought LARP-safe arrows only (No homemade arrows will be considered).
  • Safety has the final say whether the bow/crossbow is suited for game.

Store bought (manufactured) Latex weapons[edit]

These weapons are acceptable so long as they pass the safety check.

Cloth, Latex, or Duct Tape?[edit]

Most weapons at Shadow Accord are latex weapons. These look nice. Good looking weapons help with immersion, just like good costumes and props.

Cloth covered boffers are primarily used for natural weapons like claws, tentacles, or fists. A basic description of how to build cloth covered boffers is available below.

As with all weapons presented at game, a weapon needs to pass both safety AND aesthetics. Duct tape is an acceptable material provided it can pass both.

Construction materials[edit]

Cores:[edit]

Acceptable core materials:[edit]

  • Composite materials - Kite Spar/Graphite/Carbon fiber/Fiberglass core(graphite/carbon fiber are common materials used in the shaft of a golf club driver. these can be acquire at second hand stores for as little as 5 dollars each and remain acceptable for use as the core of a boffer weapon).

Un-acceptable core materials:[edit]

  • Organic materials - this includes, Wood, Bamboo, Rattan, ect. that can mold and mildew.
  • PVC - On the whole lightweight PVC is too flexible for our standards, while PVC that is rigid enough, is too heavy for our standards.

Closed cell foam:[edit]

Exterior:[edit]

  • Latex - for shaped / “bladed” weapons.
    • Latex weapons must be sealed with silicone protectant (some players are allergic to latex).
  • Cloth (Black in color) - Brawl boffers, claws boffers, & tentacle boffers.
    • Claws and tentacles must be black in color with the appropriate white/silver mark.
    • Claws and tentacles can be made of latex; they must still be black in color and carry the correct symbol.
    • Claw and Tentacle symbol examples.

Construction:[edit]

  • Foam must be secured to the core and immobile, either with glue or tape.
  • Tape may be used during construction of the core to cover the tip to prevent it from puncturing foam.
  • Tip must be padded to prevent the core from stabbing through.
  • Latex weapons are recommended to include additional tip security, such as vinyl tubing between the hard core and the foam at the tip.
  • Pommels are required for weapons donated to Shadow Accord.
  • The outer layer of all non-latex boffers must have a cloth covering.

Other Notes[edit]

  • Any member of Staff can remove an item from game if it is determined to be unsafe or very distracting to the immersion of the game. (A rule that has always been apart of Shadow Accord, though rarely used).
  • Additional information on weapons can be found in the rules.